Hello, good afternoon.
Please your support and collaboration.
I would like to comment that the Raid are being generated in Panorama ( M-200 ), and after 48 hours approx, the Pair A with A1 and A2. I finish OK.
Now it's time for B with B1 and B2.
In B1 I applied this command to add it:
request system raid add B1
After a few minutes it appeared as Pair B Busy Add in progress. Now it is out of that state and it is Active/degraded.
Now my doubt is that to review with show system raid details B1 appears in its status as:
B1 Status "Not in Use". Is this normal? It would be enough with request system raid add B2 to start the PAIR B Raid ? Or this indicates that something happens in B1 and that's why its Status Not in Use or it is normal and you have to continue with request system raid add B2.
This did not happen to me when I set up the Raid with A1 and A2 and I did the same process, i.e.: request system raid add A1 and request system raid add A2.
Please your support and collaboration, thank you
I remain attentive to your comments.
Best regards.