Two Static Route - Same destination, Same metric
Hello, good afternoon, thank you very much for your time, collaboration, time and suggestions.
Thinking in an environment where you have two routes to the same segment, example a pair of static routes through the Switch Core to LAN resources or two routes to the same destination, by two tunnels interfaces of a pair of VPN Site to Site to Azure.
According to the above, if I indicate the same route, to the same destination, with the same metric, but different interfaces, Palo Alto will generate an error when placing a route, to the same destination with the same metric ? Demanding to adjust the metric values or asking to enable ECMP ? And if it does not generate an error, in this case, which route will be used if both have the same metric ? which one goes from the RIB to the FIB ?
Thank you for your support, collaboration and time.
I remain attentive to your comments.
Best regards
Commit should (I think it does with a pretty clear error message) fail as that's an illegal config unless you have ecmp enabled.